Ceramic Coating

Ceramic Coatings, also called Glass Coatings or Quartz Coatings, are the most capable form of protection from UV and Chemical Damage we can utilize. The bonding molecule that provides the protection is SiO2, or Silica Dioxide. A solvent carrier is used to apply the SiO2 to the paint and other surfaces. The solvent evaporates out and leaves the SiO2 behind to cure and bond to the surface.

Unfortunately there is a bit of irresponsible marketing in the Coating world. Coatings are not thick enough nor hard enough to withstand scratches from say a dirty wash mitt, a key, or a rock chip. They do produce a slightly harder surface than the paint itself, but not enough to withstand this type of damage. The 9h Hardness measure that is used describes the Coating’s “vertical hardness”, or its ability to withstand penetration from UV and chemical damage and keep it from reaching the paints finish. That is what we are asking Coatings to do. We coat cars so that they still look good years down the road, and do not suffer from the slow roll of UV and environmental contamination that degrades the finish. Where a Coating can play in to scratch resistance is by producing and extremely repellent and slick surface, so that the surface lets go of loose dirt that you would otherwise move across the paint when washing and minimize the friction between the dirt, your wash mitt, and the paint.

The chemical makeup of Ceramic Coatings does three very important things differently than that of a wax or sealant. Firstly, it is capable of bonding to the surface underneath for a matter of years where we see a few months out of most waxes or sealants. Secondly, the chemical makeup of the Ceramic Coating is able to withstand penetration of UV and harmful environmental contaminants to keep your paints finish from degrading over time due to exposure. Thirdly, the Coating produces a highly repellent surface, where dirt and contaminant is rejected instead of absorbed in to the surface. This keeps the surfaces cleaner longer and makes regular wash maintenance very easy and safe.If you’re interested in booking an automotive ceramic coating from our Queensbury facility, simply select your preferred package above.

Every service has a DIY equivelent. So of course you can do it yourself. Will the results be similar is the real question however. Consumer grade coatings come in a wide range of qualities that don’t need to meet the discerning expectations of professional detailers. They may last less time, or not perform as well in some cases. In other cases the solvents may damage your paint, trim or be hazardous to your health to apply. A larger portion of the process comes down to the quality of prep work performed as well. Results are going to be greatly dependent on how good you can get the paint clean of any surface contamination as well as appearance before sealing it in. If you make mistakes or leave high spots and haze, it may be costly to have that repaired by professional detailer, even more costly than the initial installation would have cost due to needing to remove the coating. Choosing a professional will allow you the peace of mind to know it will be done right the first time and your car will be protected.